Table of Contents
Advertisement
Interfaces
Show SureLink status for all IPsec tunnels
To show the SureLink status all IPsec tunnels, use the
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type :
> show surelink ipsec all
IPsec Test
------ -------------------- ------------- ------------------
test 194.43.79.74 (Ping) 29 seconds
test 194.43.79.75 (Ping) 5 seconds
test1 194.43.79.74 (Ping) 21 seconds
test2 194.43.79.75 (Ping) 21 seconds
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show SureLink status for a specific IPsec tunnel
To show the SureLink status a specific IPsec tunnel, use the
command:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show surelink ipsec tunnel name
tunnel, for example:
> show surelink ipsec tunnel test
IPsec Test
------ -------------------- ------------- ------------------
test 194.43.79.74 (Ping) 29 seconds
test 194.43.79.75 (Ping) 5 seconds
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX40 User Guide
Last Response Status
Passed
Passed
Failed
Waiting for result
command to show the Surelink status of a specific
Last Response Status
Passed
Passed
Show SureLink status and statistics
show surelink ipsec all
command:
show surelink ipsec tunnel name
226
Advertisement
Table of Contents
