Table of Contents
Advertisement
Serial port
2. Click to expand the port that you want to configure for UDP serial mode.
The serial port is enabled by default. To disable, toggle off Enable.
3. For Mode, select UDP serial.
The default is Remote.
4. (Optional) For Label, enter a label that will be used when referring to this port.
5. Expand Serial Settings.
a. For Baud rate, select the baud rate used by the device to which you want to connect.
b. For Data bits, select the number of data bits used by the device to which you want to
connect.
c. For Parity, select the type of parity used by the device to which you want to connect.
d. For Stop bits, select the number of stop bits used by the device to which you want to
connect.
e. For Flow control, select the type of flow control used by the device to which you want to
connect.
6. Expand Data Framing Settings.
a. Click to expand Data Framing.
i. Click Enable to enable the data framing feature.
ii. For Maximum Frame Count, enter the maximum size of the packet. The default is
1024.
iii. For Idle Time, enter the length of time the device should wait before sending the
packet.
IX40 User Guide
Configure UDP serial mode
258
Advertisement
Table of Contents
