Show Scep Client Status And Information - Digi IX40 User Manual

Virtual Private Networks (VPN)
10. Save the configuration and apply the change
(config network scep_client Fortinet_SCEP_client)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show SCEP client status and information

You can show general SCEP client information for all SCEP clients, and specific information for an
individual SCEP client.
This procedure is only available from the Admin CLI.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured SCEP clients, type the following at the prompt:
> show scep-client
SCEP Enabled Expiry
----- ------- -------
test true
test1 false
>
3. To display details about a specific SCEP client:
> show scep-client name name
For example:
> show scep-client name test
test SCEP Status
----------------
Enabled
Client Certificate
------------------
Subject : C=US,ST=MA,L=BOS,O=Digi,OU=IT1,CN=dummy
Issuer : CN=TA-SCEP-1-CA
Serial : 1100000017A30C8EDD3805EB52000000000017
IX40 User Guide
Jun 4 19:05:25 2022 GMT
: true
IPsec
414