Table of Contents
Advertisement
Services
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the iperf service.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX40 device:
(config)> add service mqtt acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
n
To limit access based on firewall zones:
(config)> add service mqtt acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to include additional firewall zones.
6. Enable the system to write MQTT debug messages to the system log:
(config)> service mqtt debug true
(config)>
IX40 User Guide
Display a list of available interfaces:
Use ... network interface ?to display interface information:
Display a list of available firewall zones:
Type ... firewall zone ?at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be referred to by packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------------------------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Use the MQTT broker service
632
Advertisement
Table of Contents
