Table of Contents
Advertisement
Interfaces
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Select the appropriate WAN or WWAN on which SureLink should be disabled..
5. After selecting the WAN or WWAN, click SureLink.
6. Toggle off Enable to disable SureLink.
7. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change to the WAN or WWAN's node in the configuration schema. For example, to disable
SureLink for the Modem interface:
(config)> network interface modem
(config network interface modem)>
4. Disable SureLink:
(config network interface modem> surelink enable false
(config network interface modem)>
IX40 User Guide
Wide Area Networks (WANs)
115
Advertisement
Table of Contents
