Table of Contents
Advertisement
Diagnostics
4. Click to download the system log.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show log
> show log
Timestamp
-------------- -------------------------------------------------------------
Nov 26 21:54:34 IX40 netifd: Interface 'interface_wan' is setting up now
Nov 26 21:54:35 IX40 firewalld[621]: reloading status
...
>
3. (Optional) Use the show log number num command to limit the number of lines that are
displayed. For example, to limit the log to the most recent ten lines:
> show log number 10
Timestamp
-------------- -------------------------------------------------------------
Nov 26 21:54:34 IX40 netifd: Interface 'interface_wan' is setting up now
Nov 26 21:54:35 IX40 firewalld[621]: reloading status
...
>
4. (Optional) Use the show log filter value command to limit the number of lines that are
displayed. Allowed values are critical, warning, info, and debug. For example, to limit the
event list to only info messages:
> show log filter info
Timestamp
---------------- ------- --------- -------------------------------------------
Nov 26 22:01:26 info user
Nov 26 22:01:25 info user
...
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX40 User Guide
command at the Admin CLI prompt:
Message
Message
Type Category Message
name=admin~service=cli~state=opened~remote=192.168.1.2
name=admin~service=cli~state=closed~remote=192.168.1.2
View system and event logs
926
Advertisement
Table of Contents
