Table of Contents
Advertisement
Services
3. Enable the SNMP agent:
(config)> service snmp enable true
(config)>
4. Configure access control:
n
To limit access to specified IPv4 addresses and networks:
(config)> add service snmp acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the SNMP service.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
(config)> add service snmp acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the SNMP service.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX40 device:
(config)> add service snmp acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service snmp acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
IX40 User Guide
Display a list of available interfaces:
Use ... network interface ?to display interface information:
Display a list of available firewall zones:
Type ... firewall zone ?at the config prompt:
(config)> ... firewall zone ?
Simple Network Management Protocol (SNMP)
558
Advertisement
Table of Contents
