Table of Contents
Advertisement
Services
Repeat this step to include additional firewall zones.
Note
By default, the access control list for the NTP service is empty, which means that all
downstream hosts connected to the IX40 device can use the NTP service.
7. (Optional) Set the timezone for the location of your IX40 device. The default is UTC.
(config)> system time timezone value
(config)>
Where value is the timezone using the format specified with the following command:
(config)> system time timezone ?
Timezone: The timezone for the location of this device. This is used to adjust the time for log
messages. It also affects actions that occur at a specific time of day.
Format:
Africa/Abidjan
Africa/Accra
Africa/Addis_Ababa
...
(config)>
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
IX40 User Guide
Display a list of available firewall zones:
Type ... firewall zone ?at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be referred to by packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------------------------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Network Time Protocol
616
Advertisement
Table of Contents
