Table of Contents
Advertisement
Interfaces
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces > Modem > APN list > APN.
4. For APN, type the Access Point Name (APN) to be used when connecting to the cellular carrier.
5. (Optional) IP version:
For IP version, select one of the following:
n
Automatic: Requests both IPv4 and IPv6 address.
n
IPv4: Requests only an IPv4 address.
n
IPv6: Requests only an IPv6 address.
The default is Automatic.
6. (Optional)For PDP context index, type the number for the index of the SIM card that the APN
is programmed into or type 0 to have the index set automatically.
7. (Optional) For Authentication method, select one of the following:
n
None: No authentication is required.
n
Automatic: The device will attempt to connect using CHAP first, and then PAP.
n
CHAP: Uses the Challenge Handshake Authentication Profile (CHAP) to authenticate.
n
PAP: Uses the Password Authentication Profile (PAP) to authenticate.
If Automatic, CHAP, or PAP is selected, enter the Username and Password required to
authenticate.
The default is None.
8. Lightweight M2M support is enabled by default. Disable if you are using an AT&T SIM that
does not support AT&T lightweight M2M.
9. To add additional APNs, for Add APN, click g and repeat the preceding instructions.
10. (Optional) To configure the device to bypass its preconfigured APN list and only use the
configured APNs, enable APN list only.
IX40 User Guide
Wide Area Networks (WANs)
132
Advertisement
Table of Contents
