Table of Contents
Advertisement
Routing
9. Save the configuration and apply the change
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example: VRRP/VRRP+ configuration
This example configuration creates a VRRP pool containing two IX40 devices:
Configure device one (master device)
É
Web
Task 1: Configure VRRP on device one
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
IX40 User Guide
(Optional) Set the amount of time to wait for an initial connection to the
l
interface before this test is considered to have failed:
(config network interface eth2 ipv4 surelink target 0)> interface_timeout value
(config network interface eth2 ipv4 surelink target 0)>
where value is any number of weeks, days, hours, minutes, or seconds, and
takes the format number{w|d|h|m|s}.
For example, to set interface_timeout to ten minutes, enter either 10m or
600s:
(config network interface eth2 ipv4 surelink target 0)> interface_timeout 600s
(config network interface eth2 ipv4 surelink target 0)>
The default is 60 seconds.
Use Digi Remote Manager to view and manage your
Virtual Router Redundancy Protocol (VRRP)
341
Advertisement
Table of Contents
