Table of Contents
Advertisement
Serial port
a. To enable logging, click to toggle on Enable.
b. In the Log file name field, enter a descriptive name for the log file.
c. For Log file size, type the size of the log file. When the log file reaches the size limit, the
current file is saved and a new file is created. The default is 65536 bytes.
d. From the Type of data to log list box, specify the type of data that should be saved.
n
n
n
n
e. If you want to log the time at which date was received or transmitted, click the
Timestamps toggle to Enable.
f. If you want to log the data as hexadecimal values, click the Hexadecimal toggle to
Enable.
Note
You can review the message log in the Serial Port Log page. See
port message
8. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. The serial port is enabled by default. To disable:
(config)> serial port1 enable false
(config)>
4. Set the mode:
(config)> serial port1 mode realport
(config)>
5. Set the sharing mode:
(config)> serial port1 sharing value
(config)>
where value is one of:
n
none: Only the user that opened the port can change the port settings. All other users
are rejected. No other users can receive data from the port. This is the default.
IX40 User Guide
Advanced RealPort configuration without using the Digi Navigator
Received
Transmitted
Both
Both with arrows. This is the default.
log.
Review the serial
290
Advertisement
Table of Contents
