Digi IX40 User Manual page 198

Interfaces
The default is auto.
f. Set the IP address or host name of the TFTP server:
(config)> network interface my_lan ipv4 dhcp_server advanced nftp_server ip_address
(config)>
g. Set the relative path and file name of the bootfile on the TFTP server:
(config)> network interface my_lan ipv4 dhcp_server advanced bootfile filename
(config)>
h. Enable BOOTP dynamic allocation to automatically assign an IP address to a device on
the server:
(config)> network interface my_lan ipv4 dhcp_server advanced bootp_dynamic true
(config)>
9. See Configure DHCP options
10. See Map static IP addresses to hosts
11. Save the configuration and apply the change
(config network interface my_lan ipv4 dhcp_server advanced static_lease 0)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Map static IP addresses to hosts
You can configure the DHCP server to assign static IP addresses to specific hosts.
Required configuration items
IP address that will be mapped to the device.
n
MACaddress of the device.
n
Additional configuration items
A label for this instance of the static lease.
n
To map static IP addresses:
É
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
IX40 User Guide
CAUTION! The IP address assigned to the device is leased forever and becomes
permanently unavailable for other hosts to use.
for information about custom DHCP options.
for information about static leases.
Local Area Networks (LANs)
198