Table of Contents
Advertisement
Serial port
If altpin is disabled, the hardware signal on RJ45 pin 1 becomes DSR instead of DCD. This
alternative can be used if DCD is not required, and DSR is needed instead.
6. Set a label that will be used when referring to this port.
(config)> serial port1 label label
(config)>
7. (Optional) Set a label that will be used when referring to this port.
(config)> serial port1 label label
(config)>
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the RealPort service
After you have configured RealPort mode on the Connect EZ, you must enable and configure the
RealPort service. When this step is complete, all of the serial ports on the Connect EZ are configured
to use the RealPort service.
WebUI
1. Log into the Connect EZ WebUI as a user with Admin access.
2. On the menu, click System > Configuration > Device Configuration.
3. Expand Services.
4. Expand RealPort.
5. Click Enable to enable the RealPort service.
6. For RealPort Server Port, enter 1027.
7. Enable Encryption to enable encryption of data. This is enabled by default.
8. (Optional) For Shared Secret, enter the key to ensure secure communication. Leave this field
blank to disable authentication.
9. Enable Exclusive Mode to ensure that any connection from an IP address is closed when
opening a new connection from the same IP address. This disabled by default.
10. Enable RealPort Keepalive to send RealPort keepalive packets. This is enabled by default.
11. Enable TCP Port Keepalive to send TCP keepalive packets. This is disabled by default.
12. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.
Digi Connect EZ 4/4i User Guide
Configure RealPort mode
194
Advertisement
Table of Contents
