Digi IX40 User Manual page 190

Interfaces
Log into the IX40 WebUI as a user with full Admin access rights.
1. From the menu, click Status.
2. Under Networking, click Interfaces.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
---------------- ----- ------- -------------------------------
defaultip
defaultlinklocal IPv4 up
eth1
eth1
eth2
eth2
loopback
modem
modem
>
3. Additional information can be displayed by using the
> show network verbose
Interface
---------------- ----- ------- ------ -------- -------- ------ ------
defaultip
defaultlinklocal IPv4 up
eth1
eth1
eth2
eth2
loopback
modem
modem
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific LAN. For example, to display information about ETH2, enter show
network interface eth2:
IX40 User Guide
command at the Admin CLI prompt:
Proto Status Address
IPv4 up 192.168.210.1/24
169.254.100.100/16
IPv4 up 10.10.10.10/24
IPv6 up fe00:2404::240:f4ff:fe80:120/64
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
IPv4 up 10.200.1.101/30
IPv6 down
Proto Status Type Zone
IPv4 up static setup
static setup
IPv4 up dhcp external eth1
IPv6 up dhcp external eth1
IPv4 up static internal eth2
IPv6 up static internal eth2
IPv4 up static loopback loopback 0
IPv4 up modem external wwan1
IPv6 down modem external wwan1
show network verbose
Device Metric Weight
eth2 10 10
eth2 0 10
1 10
1 10
5 10
5 10
10
3 10
3 10
Local Area Networks (LANs)
command:
190