Table of Contents
Advertisement
Services
v. You can change the Mode that the interface will use:
vi. Repeat for additional interfaces.
For example, if you want to bond a wired WAN Ethernet with a cellular modem, add
two bonded interfaces: the ETH1 Ethernet interface and Modem cellular interface.
f. Click Save.
4. Create a site-specific settings file for the Tunnel username and Tunnel password options:
a. Click Home.
b. Click and select Download to download a CSV file to your local filesystem, which you
can use to set site-specific settings.
IX40 User Guide
n
Automatic: Automatically sets the mode to Cellular Optimized for Speed-mode
for cellular, and Ethernet for non-cellular. This is the default mode.
n
Cellular Optimized for Speed: A general-purpose configuration suitable for
most lines (4G, DSL, etc), with a fair tolerance for packet loss and latency.
n
Cellular Optimized for Latency: Another preset for mobile connections with
an even higher focus on latency.
Ethernet: A preset for direct Ethernet connections, very sensitive to latency
n
and packet loss.
Low Latency: Similar to Ethernet preset, but with higher tolerance for packet
n
loss.
TCP Mode: Utilizes TCP instead of UDP. Higher throughput rate at the cost of
n
latency. Useful in scenarios where UDP is throttled or blocked.
WAN bonding
546
Advertisement
Table of Contents
