Digi IX40 User Manual page 395

Virtual Private Networks (VPN)
6. Add recovery actions:
a. Type ... to return to the root of the configuration:
(config vpn ipsec tunnel ipsec_example surelink tests 1)> ...
(config)>
b. Add a recovery action:
(config)> add vpn ipsec tunnel ipsec_example surelink actions end
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
c. New actions are enabled by default. To disable:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> enable false
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
d. Create a label for the action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> label string
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
e. Set the type of recovery action to reboot_device:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> action reboot_device
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
n
n
f. Set the type of recovery action. If multiple recovery actions are configured, they are
performed in the order that they are listed. The command varies depending on whether
the interface is a WAN or WWAN:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> modem_action value
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
n
IX40 User Guide
Set the number of failures for this recovery action to perform, before moving to the
next recovery action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> test_failures int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 3.
Set the time to wait before the next test is run. If set to the default value of 0s, the
test interval is used.
(config vpn ipsec tunnel ipsec_example surelink actions 0)> override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
WAN interfaces:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> action value
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
IPsec
395