Show Wan Bonding Status And Statistics - Digi IX40 User Manual

Services
b. Repeat for each additional interface.
9. Enable Bonding Proxy to further optimize standard TCP traffic.
(config network sdwan wan_bonding)
(config)>
10. Set the password for authentication to the WAN bonding web interface.
The WAN bonding web interface can be used to view detailed WAN bonding statistics and to
fine-tune the WAN bonding process, and is accessed via a web browser at http://ip-
address:8088, where ip-address is the IP address of the local IX40 device.
(config)> network sdwan wan_bonding web_interface password password
(config)>
11. Save the configuration and apply the change
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show WAN bonding status and statistics

You can display status and statistics for WAN bonding. This command is available only at the Admin
CLI.
É
Web
Log into the IX40 WebUI as a user with full Admin access rights.
1. On the main menu, click Status.
2. Under Networking, click WAN bonding.
The current status of the device's bonding interfaces is displayed.
Command line
Show WAN bonding information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
IX40 User Guide
n mobileLowLatency: Another preset for mobile connections with an even
higher focus on latency.
n ethernet: A preset for direct Ethernet connections, very sensitive to latency
and packet loss.
n lowLatency: Similar to Ethernet preset, but with higher tolerance for packet
loss.
genericTCP: Utilizes TCP instead of UDP. Higher throughput rate at the cost of
n
latency. Useful in scenarios where UDP is throttled or blocked.
WAN bonding
552