Table of Contents
Advertisement
System administration
3. In the Configuration backup section, click SAVE.
Do not set a Passphrase for the configuration backup. The file will be downloaded using your
browser's standard download process.
4. After the configuration backup file has been downloaded, rename the file to:
custom-default-config.bin
5. Upload the file to the device:
a. From the main menu, select System > Filesystem.
b. Under Default device configuration, click “ .
c. Select the file from your local file system.
6.
Reboot
the device.
Note
After configuring a device to use custom factory default settings, wait five minutes after
restoring to defaults before:
Powering off the device.
n
Performing any additional
n
If you do not wait five minutes after restoring to custom factory defaults before performing these
activities, the device will clear the custom factory defaults and reboot to standard factory defaults.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the following:
> system backup / type custom-defaults
Backup saved as /opt/custom-default-config.bin
>
IX40 User Guide
Erase device configuration and reset to factory defaults
configuration restoration
activities.
867
Advertisement
Table of Contents
