Table of Contents
Advertisement
Applications
Log into the IX40 WebUI as a user with full Admin access rights.
1. At the Status page, click Scripts.
The Scripts page displays:
2. For scripts that are enabled and configured to have a run mode of Manual, click Start Script
to start the script.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Determine the name of scripts that are currently running:
> show scripts
Index Label
----- ----------- ------- ------ --------
0
script1
1
script2
>
3. Start the script:
)> system script start script1
>
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX40 User Guide
Enabled Status Run time
true
active
true
idle
01:00
Start a manual script
709
Advertisement
Table of Contents
