Table of Contents
Advertisement
Services
Configure the location service
The location service is enabled by default. You can disable it, or you can enable it if it has been
disabled.
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location.
4. The location service is enabled by default. To disable, or to enable if it has been disabled, click
Enable.
5. For Location update interval, type the amount of time to wait between polling location
sources for new location data. The default is ten seconds.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Location update interval to ten minutes, enter 10m or 600s.
6. For information about configuring Location sources, see the following:
a. For modem-based GNSS, see
b. To set a static location for the device, see
location.
c. To accept location information from an external location-enabled server, see
device to accept location messages from external
IX20 User Guide
Enable or disable modem
Configure the device to use a user-defined static
sources.
Location information
GNSS support.
Configure the
446
Advertisement
Table of Contents
