Table of Contents
Advertisement
About the Digi IX40
3. Set the signalling mode:
(config)> serial port1 signal_mode value
(config)>
where value is one of:
n
rs-232
n
rs-422
n
rs-485
If this is the end device along a cabled RS-485 daisy chain and termination resistors are
recommended, enable an internal electrical termination:
(config)> serial port1 termination true
(config)>
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX40 serial pinouts
IX40 User Guide
Digi IX40 external hardware
33
Advertisement
Table of Contents
