Digi IX40 User Manual page 185

Interfaces
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Create a bridge that includes the WAN/ETH1 port
This procedure will bridge the WAN/ETH1 port with the ETH2 port, which will configure the two
Ethernet ports to function as a hub.
To bridge the IX40 device's WAN/ETH1 Ethernet port with the ETH2 port:
É
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Create the bridge and add devices:
a. Click Network > Bridges.
b. For Add Bridge, type a name for the bridge and click g .
c. Click to expand Devices.
IX40 User Guide
Use Digi Remote Manager to view and manage your
Local Area Networks (LANs)
185