Table of Contents
Advertisement
Services
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > telnet.
4. (Optional) For Port, enter the port number for the service. Normally this should not be
changed.
5. Click Access control list to configure access control:
To limit access to specified IPv4 addresses and networks:
n
a. Click IPv4 Addresses.
b. For Add Address, click g .
c. For Address, enter the IPv4 address or network that can access the device's telnet
d. Click g again to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
a. Click IPv6 Addresses.
b. For Add Address, click g .
c. For Address, enter the IPv6 address or network that can access the device's telnet
d. Click g again to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX40 device:
a. Click Interfaces.
b. For Add Interface, click g .
c. For Interface, select the appropriate interface from the dropdown.
d. Click g again to allow access through additional interfaces.
n
To limit access based on firewall zones:
a. Click Zones.
b. For Add Zone, click g .
c. For Zone, select the appropriate firewall zone from the dropdown.
d. Click g again to allow access through additional firewall zones.
IX40 User Guide
service. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the telnet service.
l
service. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the telnet service.
l
See
Firewall configuration
for information about firewall zones.
Configure telnet access
534
Advertisement
Table of Contents
