Table of Contents
Advertisement
Virtual Private Networks (VPN)
n
n
n
n
e. Repeat for each additional test.
12. Add recovery actions:
a. Click to expand Recovery actions.
By default, there are two preconfigured recovery actions:
IX40 User Guide
Test the interface status: Tests the current status of the interface. The test fails if
the interface is down. Failing this test infers that all other tests fail.
If Test the interface status is selected, complete the following:
Down time: The amount of time that the interface is down before the test can
l
be considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Down time to ten minutes, enter 10m or 600s.
Initial connection time: The amount of time to wait for the interface to
l
connect for the first time before the test is considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Initial connection time to ten minutes, enter 10m or 600s.
Custom test: Tests the interface with custom commands.
If Custom test is selected, complete the following:
The Commands to run to test.
l
TCP connection test: Tests that the interface can reach a destination port on the
configured host.
If TCP connection test is selected, complete the following:
TCP connect host: The hostname or IP address of the host to create a
l
TCP connection to.
TCP connect port: The TCP port to create a TCP connection to.
l
Test another interface's status: Tests the status of another interface.
If Test another interface's status is selected, complete the following:
Test interface: The interface to test.
l
IP version: The type of IP connection, one of:
l
o
Any: Either the IPv4 or IPv6 connection must be up.
o
Both: Both the IPv4 or IPv6 connection must be up.
o
IPv4: The IPv4 connection must be up.
o
IPv6: The IPv6 connection must be up.
Expected status: The status required for the test to past.
l
o
Up: The test will pass only if the referenced interface is up and passing its
own SureLink tests (if applicable).
o
Down: The test will pass only if the referenced interface is down or failing its
own SureLink tests (if applicable).
IPsec
388
Advertisement
Table of Contents
