Ethernet Network Bonding - Digi IX40 User Manual

Services
3. Add the multicast route. For example, to add a route named test:
(config)> add service multicast test
(config service multicast test)>
4. The multicast route is enabled by default. If it has been disabled, enable the route:
(config service multicast test)> enable true
(config service multicast test)>
5. Set the source address for the route. This must be a multicast IP address between 224.0.0.1
and 239.255.255.255.
(config service multicast test)> dst ip-address
(config service multicast test)>
6. Set the source interface for the route where multicast packets will arrive:
a. Use the ?to determine available interfaces:
b. Set the interface. For example:
(config service multicast test)> src_interface /network/interface/eth1
(config service multicast test)>
7. Set a destination interface that the IX40 device will send mutlicast packets to:
a. Use the ?to determine available interfaces:
b. Set the interface. For example:
(config service multicast test)> add interface end /network/interface/eth1
(config service multicast test)>
c. Repeat for each additional destination interface.
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Ethernet network bonding

The IX40 device supports bonding mode for the Ethernet network. This allows you to configure the
device so that Ethernet ports share one IP address. When both ports are being used, they act as one
Ethernet network port.
IX40 User Guide
Ethernet network bonding
619