Digi IX40 User Manual page 396

Virtual Private Networks (VPN)
n
where value is one of:
n
n
n
IX40 User Guide
WWAN interfaces:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> modem_action value
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
update_routing_table: Increases the interface's metric to change the default
gateway.
If update_routing_table is selected, complete the following:
Set the number of failures for this recovery action to perform, before moving to
l
the next recovery action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> test_failures int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 3.
Set the amount that the interface's metric should be increased. This should be
l
set to a number large enough to change the routing table to use another
default gateway.
(config vpn ipsec tunnel ipsec_example surelink actions 0)> metric_adjustment_
modem int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 100.
Set the time to wait before the next test is run. If set to the default value of 0s,
l
the test interval is used.
(config vpn ipsec tunnel ipsec_example surelink actions 0)> override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
restart_interface.
If restart_interface is selected, complete the following:
Set the number of failures for this recovery action to perform, before moving to
l
the next recovery action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> test_failures int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 3.
Set the time to wait before the next test is run. If set to the default value of 0s,
l
the test interval is used.
(config vpn ipsec tunnel ipsec_example surelink actions 0)> override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
reset_modem: This recovery action is available for WWAN interfaces only.
If reset_modem is selected, complete the following:
IPsec
396