Configure The Location Service - Digi TX54 User Manual

Services

Configure the location service

The location service is enabled by default. You can disable it, or you can enable it if it has been
disabled.

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location.
4. The location service is enabled by default. To disable, or to enable if it has been disabled, click
Enable.
5. For Location update interval, type the amount of time to wait between polling location
sources for new location data. The default is ten seconds.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Location update interval to ten minutes, enter 10m or 600s.
6. For information about configuring Location sources, see the following:
a. To configure a USB GNSS, see
b. To configure the internal GNSS, see
c. To set a static location for the device, see
location.
TX54 User Guide
Use a dead reckoning external USB GNSS
Enable or disable the internal GNSS
Configure the device to use a user-defined static
Location information
receiver.
module.
542