Table of Contents
Advertisement
Serial port
address on your computer as well as on the device.
Step 1: Assign a generic IP address to the device
1. Make sure Digi Navigator is
network or computer with an Ethernet cable.
2. Launch the Digi Navigator.
3. Click Filters from the green toolbar to expand the toolbar and display the filter options.
4. In the Default IP Filters section, click the enable button for the 192.168.210.1 option.
5. Click Filters at the bottom of the expanded toolbar to minimize the toolbar and hide the
filters.
Step 2: Assign the IP address to your computer
You must also manually assign this IP address to your computer to ensure a connection. Both your
computer and device must be connected to a private network that does not have a DHCP server.
1. Use an Ethernet cable to connect the device and your computer. Both your computer and
device must be connected to your private network.
2. On your PC, navigate to the Ethernet network settings dialog.
3. Click the Internet Protocol Version 4 (TCP/IPv4) parameter.
IX40 User Guide
Configure RealPort mode using the Digi Navigator
installed
and the IX40 is powered and connected to your local
279
Advertisement
Table of Contents
