Table of Contents
Advertisement
Containers
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click System > Containers.
4. For Add Container, type the name of the container and click g .
The Container configuration window is displayed.
New containers are enabled by default. To disable, toggle off Enable.
5. Clone host system libraries is enabled by default. This allows the container to use the
device's system libraries.
6. Enable Virtual Network if the container should have network access:
a. Select a Network Bridge Device that will provide access to the container.
b. (Optional) Enter a static IP Address and netmask for the container. This must be a valid IP
address for the bridge, or, if left blank, a DHCP server can assign the container an IP
address.
c. (Optional) For Gateway, type the IP address of the network gateway.
7. Enable Start on boot to configure the container to start when the system boots.
a. For Restart timeout, set the amount of time to wait before restarting the container, if the
container ever stops. The default timeout of 0s means that if the container stops, it will
not be restarted.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Restart timeout to ten minutes, enter 10m or 600s.
8. (Optional) Type any Optional parameters for the container. Parameters are in the format
accepted by the lxc utility.
9. (Optional) Type a Working directory to configure an initial working directory for the container.
The directory is an absolute path within the container and must begin with "/". The default is /.
IX40 User Guide
Configure a container
822
Advertisement
Table of Contents
