Digi IX40 User Manual page 589

Services
Log into the IX40 WebUI as a user with full Admin access rights.
1. On the main menu, click Status.
2. Under Services, click Location.
The device's current location is displayed, along with the status of any configured geofences.
Command line
Show location information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show location
> show location
Location Status
---------------
State
Source
Latitude
Longitude
Altitude
Velocity
Direction
Quality
UTC Date and Time : Fri, Jan 12, 2024 12:10:00 03
No. of Satellites : 7
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show geofence information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show location geofence
> show location geofence
Geofence
------------- ------ ------ ----------- ---------------
test_geofence Up
IX40 User Guide
command at the system prompt:
: enabled
: 192.168.2.3
: 44* 55' 14.809" N (44.92078)
: 93* 24' 47.262" w (-93.413128)
: 279 meters
: 0 meters per second
: None
: Standard GNSS (2D/3D)
command at the system prompt:
Status State Transitions Last Transition
Inside 0
Location information
589