Locate The Device By Using The Find Me Feature - Digi IX40 User Manual

System administration
3. Reboot the device:
> reboot
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Note After configuring a device to use custom factory default settings, wait five minutes after
restoring to defaults before:
n Powering off the device.
n Performing any additional
If you do not wait five minutes after restoring to custom factory defaults before performing these
activities, the device will clear the custom factory defaults and reboot to standard factory defaults.
Clear the custom factory default settings
After configuring the device to use custom factory default settings, to clear the custom default
configuration and reset the device to standard factory defaults:
1. Press the device's
2. Wait for the device to reboot.
3. Press the ERASE button a second time.
You must press the ERASE the second time within five minutes of the first in order to clear the custom
default configuration.

Locate the device by using the Find Me feature

Use the Find Me feature to cause LEDs on the device to blink, which can help you to identify the
specific device.
To use this feature:
É
Web
Log into the IX40 WebUI as a user with full Admin access rights.
1. On the menu, click System. Under Administration, click Find Me.
A notification message appears, noting that the LED is flashing on the device. Click the x in the
message to close it.
2. On the menu, click System again. Ablue circle next to Find Me is blinking, indicating that the
Find Me feature is active.
IX40 User Guide
configuration restoration
ERASE button.
Locate the device by using the Find Me feature
activities.
868