Show Captured Traffic Data - Digi IX40 User Manual

Diagnostics
capture_ping
> analyzer stop name

Show captured traffic data

To view captured data traffic, use the
following information for each packet:
The packet number.
n
The timestamp for when the packet was captured.
n
The length of the packet and the amount of data captured.
n
Whether the packet was sent or received by the device.
n
The interface on which the packet was sent or received.
n
A hexadecimal dump of the packet of up to 256 bytes.
n
Decoded information of the packet.
n
To show captured data traffic:
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Type the following at the Admin CLI prompt:
> show analyzer name capture_filter
Packet 1 : Sept-29-2023 12:10:00.287682, Length 60 bytes (Captured Length 60 bytes)
Received on interface eth1
00 40 ff 80 01 20 b4 b6 86 21 b5 73 08 00 45 00 .@... .. .!.s..E.
00 28 3d 36 40 00 80 06 14 bc 0a 0a 4a 82 0a 0a .(=6@... ....J..
4a 48 cd ae 00 16 a4 4b ff 5f ee 1f d8 23 50 10 JH.....K ._...#P.
08 02 c7 40 00 00 00 00 00 00 00 00
Ethernet Header
Destination MAC Addr : 00:40:D0:13:35:36
Source MAC Addr
Ethernet Type
IP Header
IP Version
Header Length
ToS
Total Length
ID
Flags
IX40 User Guide
show analyzer
: fb:03:53:05:11:2f
: IP (0x0800)
: 4
: 20 bytes
: 0x00
: 40 bytes
: 15670 (0x3d36)
: Do not fragment
command. The command output show the
...@.... ....
Analyze network traffic
949