Table of Contents
Advertisement
Digi IX40 Quick start
f. Turn the SIM Card Tray over.
g. With the metal contacts on the SIM Card facing up, push the SIM Card into the Tray.
h. Grease the metal contacts, if needed.
Note
If the Digi IX40 is used in an environment with high vibration levels, fretting may
cause unexpected SIM card failures. To protect the SIM cards, Digi strongly recommends
that you apply a thin layer of dielectric grease to the SIM contacts prior to inserting the
SIM card. For more information, see
i. Turn the SIM Card Tray over again.
The metal contacts now face down.
j. To re-insert the SIM Card Tray, push it back into the SIM Card Slot (top).
k. Push lightly on the SIM Card Tray until it clicks.
l. If you have another SIM Card, repeat this procedure to insert it into SIM Card Tray 2
(bottom).
m. Re-attach the SIM Cover and hand-tighten the screw.
2. Attach and hand-tighten the four cellular antennas to the WWAN1, WWAN2, WWAN3, and
WWAN4 ports.
3. To connect the Digi IX40 to the internet, attach the Ethernet cable into the WAN/ETH1 port and
then connect the other end of the cable to a device with internet connectivity (e.g., corporate
IX40 User Guide
CAUTION! Make sure to line up the SIM Card Tray with the top SIM Card Slot.
There is a space at the top. If you do not align the SIM Card Tray with the Sim
Card Slot, the SIM Card Tray could fall into the Digi IX40.
CAUTION! When tightening the screw, do not exceed 2 lb-in. (225 nM-m) of
torque. You could damage the SIM Card Cover or the SIM slots inside the Digi IX40.
Step 1: Connect your Digi IX40
Apply dielectric
grease.
19
Advertisement
Table of Contents
