Digi IX40 User Manual page 113

Interfaces
c. If more than one test target is configured, set the success condition:
(config)> network interface my_wan surelink success_condition value
(config)>
where value is either:
n
n
d. Set the number of times that the test must pass after failure, before the interface is
determined to be working and is reinstated.
(config)> network interface my_wan surelink pass_threshold int
(config)>
The default is 1.
e. Set the amount of time that the device should wait for a response to a test failure before
considering it to have failed:
(config)> network interface my_wan surelink timeout value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set timeout to ten minutes, enter either 10m or 600s:
(config)> network interface my_wan surelink timeout 600s
(config)>
The default is 15s.
f. Set the amount of time to wait while the device is starting before SureLink testing begins.
This setting is bypassed when the interface is determined to be up.
(config)> network interface my_wan surelink advanced delayed_start value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set delayed_start to ten minutes, enter either 10m or 600s:
(config)> network interface my_wan surelink advanced delayed_start 600s
(config)>
The default is 300s.
g. Set the time to add to the test interval when restarting the list of actions. This option is
capped at 15 minutes.
(config)> network interface my_wan surelink advanced backoff_interval value
(config)>
IX40 User Guide
one: Only one test needs to pass for Surelink to consider an interface to be up.
all: All tests need to pass for SureLink to consider the interface to be up.
Wide Area Networks (WANs)
113