Digi IX40 User Manual page 583

Services
where name is a name for the geofence. For example:
(config)> add service location geofence test_geofence
(config service location geofence test_geofence)>
The geofence is enabled by default. To disable:
(config service location geofence test_geofence)> enable false
(config service location geofence test_geofence)>
4. Set the amount of time that the geofence should wait between polling for updated location
data:
(config service location geofence test_geofence)> update_interval value
(config service location geofence test_geofence)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set update_interval to ten minutes, enter either 10m or 600s:
(config service location geofence test_geofence)> update_interval 600s
(config service location geofence test_geofence)>
The default is 1m (one minute).
5. Set the boundary type for the geofence:
(config service location geofence test_geofence)> boundary value
(config service location geofence test_geofence)>
where value is either circular or polygonal.
If boundary is set to circular :
n
a. Set the latitude and longitude of the center point of the circle:
b. Set the radius of the circle:
If boundary is set to polygonal:
n
a. Set the coordinates of one vertex of the polygon. A vertex is the point at which two
IX40 User Guide
(config service location geofence test_geofence)> center latitude int
(config service location geofence test_geofence)> center longitude int
(config service location geofence test_geofence)>
where int is:
For latitude, any integer between -90 and 90, with up to six decimal places.
l
For longitude, any integer between -180 and 180, with up to six decimal
l
places.
(config service location geofence test_geofence)> radius radius
(config service location geofence test_geofence)>
where radius is an integer followed by m or km, for example, 100m or 1km.
sides of a polygon meet.
Location information
583