Table of Contents
Advertisement
Interfaces
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set backoff_interval to ten minutes, enter either 10m or 600s:
(config)> network interface my_wan surelink advanced backoff_interval 600s
(config)>
The default is 300 seconds.
h. The interface_gateway parameter is used by the Interface gateway Ping test as the
endpoint for traceroute to use to determine the interface gateway. The default is 8.8.8.8,
and should only be changed if this IP address is not accessible due to networking issues.
To set to an alternate host:
(config)> network interface my_wan surelink advanced interface_gateway hostname/IP_
address
(config)>
8. Save the configuration and apply the change
(config network interface my_wan ipv4 surelink)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Disable SureLink
If your device uses a private APN with no Internet access or has a restricted WAN connection that
doesn't allow DNS resolution, you can disable SureLink connectivity tests. You can also reconfigure
SureLink to disable the DNS test and use one or more other tests.
É
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
IX40 User Guide
Use Digi Remote Manager to view and manage your
Wide Area Networks (WANs)
114
Advertisement
Table of Contents
