Show Ipsec Status And Statistics - Digi IX40 User Manual

Virtual Private Networks (VPN)
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set backoff_interval to ten minutes, enter either 10m or 600s:
(config)> vpn ipsec tunnel ipsec_example surelink advanced backoff_interval 600s
(config)>
The default is 300 seconds.
h. The interface_gateway parameter is used by the Interface gateway Ping test as the
endpoint for traceroute to use to determine the interface gateway. The default is 8.8.8.8,
and should only be changed if this IP address is not accessible due to networking issues.
To set to an alternate host:
(config)> vpn ipsec tunnel ipsec_example surelink advanced interface_gateway hostname/IP_
address
(config)>
8. Save the configuration and apply the change
(config vpn ipsec tunnel ipsec_example connection_monitor target 0)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show IPsec status and statistics

É
Web
Log into the IX40 WebUI as a user with full Admin access rights.
1. On the menu, select Status > IPsec.
The IPsec page appears.
2. To view configuration details about an IPsec tunnel, click the ­ (configuration) icon in the upper
right of the tunnel's status pane.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured IPsec tunnels, type the following at the prompt:
> show ipsec all
Name Enable Status Hostname
IX40 User Guide
IPsec
400