Digi IX40 User Manual page 97

Interfaces
b. Add a recovery action:
(config)> add network interface my_wan surelink actions end
(config network interface my_wan surelink actions 0)>
c. New actions are enabled by default. To disable:
(config network interface my_wan surelink actions 0)> enable false
(config network interface my_wan surelink actions 0)>
d. Create a label for the action:
(config network interface my_wan surelink actions 0)> label string
(config network interface my_wan surelink actions 0)>
e. Set the type of recovery action. If multiple recovery actions are configured, they are
performed in the order that they are listed. The command varies depending on whether
the interface is a WAN or WWAN:
n
n
where value is one of:
n
IX40 User Guide
WAN interfaces:
(config network interface my_wan surelink actions 0)> action value
(config network interface my_wan surelink actions 0)>
WWAN interfaces:
(config network interface my_wan surelink actions 0)> modem_action value
(config network interface my_wan surelink actions 0)>
update_routing_table: Increases the interface's metric to change the default
gateway.
If update_routing_table is selected, complete the following:
Set the number of failures for this recovery action to perform, before moving to
l
the next recovery action:
(config network interface my_wan surelink actions 0)> test_failures int
(config network interface my_wan surelink actions 0)>
The default is 3.
Set the amount that the interface's metric should be increased. This should be
l
set to a number large enough to change the routing table to use another
default gateway.
(config network interface my_wan surelink actions 0)> metric_adjustment_modem
int
(config network interface my_wan surelink actions 0)>
The default is 100.
Set the time to wait before the next test is run. If set to the default value of 0s,
l
the test interval is used.
Wide Area Networks (WANs)
97