Toshiba H1 Series Data Book page 87

(4) Interrupt request flag clear register
The interrupt request flag is cleared by writing the appropriate micro DMA /HDMA start
vector, as given in Table 3.5.1 to the register INTCLR.
For example, to clear the interrupt flag INT0, perform the following register operation after
execution of the DI instruction.
Symbol Name Address
Interrupt
INTCLR clear
control
(5) Micro DMA start vector registers
These registers assign micro DMA /HDMA processing to sets which source corresponds to
DMA. The interrupt source whose micro DMA /HDMA start vector value matches the vector set
in one of these registers is designated as the micro DMA /HDMA start source.
When the micro DMA transfer counter (DMACn) or HDMA transfer counter B (HDMACBn)
value reaches "0", the micro DMA /HDMA transfer end interrupt corresponding to the channel
is sent to the interrupt controller, the micro DMA /HDMA start vector register is cleared, and
the micro DMA /HDMA start source for the channel is cleared. Therefore, in order for micro
DMA /HDMA processing to continue, the micro DMA /HDMA start vector register must be set
again during processing of the micro DMA /HDMA transfer end interrupt.
If the same vector is set in the micro DMA /HDMA start vector registers of more than one
channel, the lowest numbered channel takes priority.
Accordingly, if the same vector is set in the micro DMA /HDMA start vector registers for two
different channels, the interrupt generated on the lower-numbered channel is executed until
micro DMA /HDMA transfer is complete. If the micro DMA /HDMA start vector for this channel
has not been set in the channel's micro DMA /HDMA start vector register again, micro DMA
/HDMA transfer for the higher-numbered channel will be commenced. (This process is known
as micro DMA /HDMA chaining.)
INTCLR ← 0AH
7
CLRV7 CLRV6
F8H
(Prohibit
0
RMW)
; Clears
flag INT0.
6 5 4
CLRV5 CLRV4
0 0 0
Interrupt vector
92CZ26A-84
TMP92CZ26A
interrupt request
3 2
CLRV3 CLRV2
W
0 0
1 0
CLRV1 CLRV0
0 0