Toshiba H1 Series Data Book page 203

3.8.5 Internal Boot ROM Control
This section describes about built-in boot ROM.
For the specification of S/W in boot ROM, refer to the section 3.4 boot ROM.
(1) BOOT mode
BOOT mode is started by following AM1 and AM0 pins condition with reset.
AM1
(2) Boot ROM memory map
Boot ROM is consist of 8-Kbyte masked ROM and assigned 3FE000H to 3FFFFFH
address.
(3) Reset/interrupt address conversion circuit
Originally, reset/interrupt vector area is assigned FFFF00H to FFFFEFH ((A) area) in
TLCS-900/H1.
But because boot ROM is assigned to another area, reset/interrupt vector address
conversion circuit is prepared.
In BOOT mode, reset/interrupt vector area is assigned 3FFF00H to 3FFFEFH ((B) area)
area by it. And after boot sequence, its area can be changed to (A) area by setting
BROMCR<VACE> to "0". So, (A) area can be used only for application system program.
This BROMCR<VACE> is initialized to "1" in BOOT mode. At another starting mode,
this register has no meaning.
Note: The last 16-byte area (FFFFF0H to FFFFFFH) is reserved for an emulator. So, this area is not changed
by <VACE> register.
AM0
0 0
0 1
1 0
1 1
000000H
Internal I/O , RAM
04A000H
3FE000H
Internal boot ROM
3FFF00H
400000H
FFFF00H
92CZ26A-200
Start mode
Don't use this setting
Start with 16-bit data bus
Don't use this setting
Start with boot (32-bit internal MROM)
(8 Kbytes)
TMP92CZ26A
(B) Reset/Interrupt
Vector area
(256 bytes)
(A) Reset/Interrupt
Vector area
(256 bytes)