Table of Contents
Advertisement
(2) Soft start function
The TMP92CZ26A can initiate micro DMA/HDMA either with an interrupt or by
using the micro DMA /HDMA soft start function, in which micro DMA or HDMA is
initiated by a Write cycle which writes to the register DMAR.
Writing "1" to each bit of DMAR register causes micro DMA or HDMA to be
performed once. On completion of the transfer, the bits of DMAR for the completed
channel are automatically cleared to "0".
When writing again "1" to it, soft start can execute continuously until the DMA
transfer counter (DMACn) or HDMA transfer counter B (HDMACBn) become "0".
When a burst is specified by the register DMAB, data is transferred continuously
from the initiation of micro DMA until the value in the micro DMA transfer counter is
"0".
Note1: If it is started by software, don't set any channels to start in same time.
Note2: If be started sequentially, restart it after confirming micro DMA of all channels is completed
(all micro DMA are set to "0").
Symbol
NAME
Address
109H
DMA
(Prohibit
DMAR
Request
RMW)
(3) Transfer control registers
The transfer source address and the transfer destination address are set in the following
registers. An instruction of the form LDC cr,r can be used to set these registers.
Channel 0
Channel 7
7
6
DREQ7
DREQ6
0
0
DMAS0
DMAD0
DMAC0
DMAM0
DMAS7
DMAD7
DMAC7
DMAM7
8 bits
16 bits
32 bits
92CZ26A-74
5
4
DREQ5
DREQ4
DREQ3
R/W
0
0
1: Start DMA
Micro DMA source address register 0
Micro DMA destination address register 0
Micro DMA counter register 0
Micro DMA mode register 0
Micro DMA source address register 7
Micro DMA destination address register 7
Micro DMA counter register 7
Micro DMA mode register 7
TMP92CZ26A
3
2
1
DREQ2
DREQ1
0
0
0
0
DREQ0
0
Advertisement
Table of Contents
