Toshiba H1 Series Data Book page 367

(4) Stop condition generation
When SBISR<BB> = "1", the sequence for generating a stop condition start by
writing "1" to SBICR2<MST, TRX, PIN> and "0" to SBICR2<BB>. Do not modify the
contents of SBICR2<MST, TRX, PIN, BB> until a stop condition has been generated
on the bus. When the bus's SCL line has been pulled Low by another device, the
TMP92CZ26A generates a stop condition when the other device has released the SCL
line and SDA pin rising.
7 6 5 4 3 2 1 0
← 1 1 0 1 1 0 0 0
SBICR2
"1" → <MST>
"1" → <TRX>
"0" → <BB>
"1" → <PIN>
Internal SCL
SCL pin
SDA Pin
<PIN>
<BB> (Read)
Figure 3.15.18 Stop condition generation (Single master)
"1" → <MST>
"1" → <TRX>
"0" → <BB>
"1" → <PIN>
Internal SCL
SCL Pin
SDA Pin
<PIN>
<BB> (Read)
Figure 3.15.19 Stop condition generation (Multi master)
Generate stop condition.
Stop condition
Stop condition
The case of pulled low
by another device
92CZ26A-364
TMP92CZ26A