Toshiba H1 Series Data Book page 509

FIFO write
<TXE>
I2SnWS pin
I2SnCKO pin
I2SnDO pin
INTI2Sn
I2SnWS pin
400kHz
I2SnCKO pin
I2SnDO pin MSB
LSB
Bit15 Bit14
Figure 3.18.6 Timing Diagrams (I2S FMT/Stereo/16bit/MSB first)
(3) Considerations for using the I
1) INTI2Sn generation timing
Every 4bytes data trance from FIFO buffer to shift register per one time.
An INTI2Sn interrupt is generated under two conditions. One is when there are 64
bytes of empty space in the FIFO (after 61- 64th byte has been transferred to the shift
register). The other is when the FIFO becomes completely empty (after 125 - 128th
byte has been transferred to the shift register). Therefore, INTI2Sn indicates that
there are 64 bytes or 128 bytes of empty space in the FIFO, enabling the next data to
be written.
The FIFO must be written in units of 64 bytes. Since the FIFO can contain 128 bytes
of data, I
in the FIFO. It is also possible to check the FIFO state by using the
I2SnCTL<TEMPn> flag.
2) I2SnCTL<TXEn>
Transmission is started by setting I2SnCTL <TXEn> to "1". Once <TXEn> is set to
"1", transmission is continued automatically as long as the FIFO contains the data to
be transmitted. While <TXE> is set to "1" (transmission in progress), the other bits in
the I2SnCTL register must not be changed.
To stop transmission, make sure that the FIFO is empty by checking the
I2SnCTL<TEMPn> flag. Then, after waiting for two periods of the I2SWS signal (after
all the data has been transmitted), set <TXEn> to "0". In case monaural setting, make
sure that the FIFO is empty by checking the I2SnCTL<TEMPn> flag. Then, after
waiting for four periods of the I2SWS signal (after all the data has been transmitted),
set <TXEn> to "0".
If <TXEn> is set to "0" while data is being transmitted, the transmission is stopped
1 2
Overall Timing Diagram
LSB
Bit0
Detailed Timing Diagram
S unit
2
S output can be performed continuously as long as there are 64 bytes of data
2
92CZ26A-506
3 4
MSB
LSB
Bit15 Bit14
Bit0
TMP92CZ26A
31 32 33
MSB
Bit15