Table of Contents
Advertisement
Services
(config service dns server 0)> domain domain
(config service dns server 0)>
d. (Optional) Set a label for this DNS server:
(config service dns server 0)> label label
(config service dns server 0)>
9. (Optional) Add host names and their IP addresses that the device's DNS server will resolve
a. Add a host:
(config)> add service dns host end
(config service dns host 0)>
b. Set the IP address of the host:
(config service dns host 0)> address ip-addr
(config service dns host 0)>
c. Set the host name:
(config service dns host 0)> name host-name
(config service dns host 0)>
10. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show DNS server
You can display status for DNS servers. This command is available only at the Admin CLI.
Command line
Show DNS information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show dns
> show dns
Interface
IX10 User Guide
command at the system prompt:
Label
Server
Configure DNS
Domain
510
Advertisement
Table of Contents
