Show Dns Server - Digi Connect IT 4 User Manual

Services
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show DNS server

You can display status for DNS servers. This command is available only at the Admin CLI.

Command line
Show DNS information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show dns
> show dns
Interface
---------
wan
wan
wan
wan
wan
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect IT® 4 User Guide
command at the system prompt:
Label Server
----- ------------------------
192.168.3.1
fd00:2704::1
fe80::227:4ff:fe2b:ae12
fe80::227:4ff:fe44:105b
fe80::240:ffff:fe80:23b0
Configure DNS
Domain
------
502