Specifications - Olympus OER-Pro Operation Manual

Specifications

ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
Compatible Olympus flexible endoscopes
scopes
(Refer to the "List of Compatible Endoscopes/Connecting Tubes
<OER-Pro>" for details)
(Note 1)
Number of
reprocessed
scopes
Cleaning method Exterior surfaces
Channel interiors
Valves
Disinfection Exterior surfaces
method
Channel interiors
Valves
Cleaning time
setting
Disinfection time Concentrated
setting disinfectant solution
Ready-to-use
disinfectant solution
Disinfectant
solution heating
setting
Disinfectant
solution heating
method
Water discharge
method
Disinfectant
solution discharge
method
Reprocessing
basin capacity
The OER-Pro does not sterilize endoscopes.
Therefore, after cleaning/disinfecting an endoscope
that requires sterilization, always sterilize the
endoscope as instructed in its instruction manual.
Max. 2 (1 with certain models)
Ultrasonic cleaning, turbulent bath
Fluid flushing
Ultrasonic cleaning, fluid flushing
Disinfectant solution immersion
Disinfectant solution flushing and filling
Disinfectant solution immersion
3 – 10 minutes (Setting variable in
1 min. increments)
7 minutes
10 minutes
20C (68F)
(If the temperature of disinfectant
solution is below 20C, it is heated to
20C (68F).)
Built-in heater in the reprocessing
basin.
1. Heating immediately before
disinfection process in a
reprocessing program
2. Heating before the start of a
reprocessing program
Forced draining using a pump (Floor
draining)
1. Draining through disinfectant
collection hose
2. Draining through drain hose
Approximately 14 L
Appendix
1
1
1
291