Care And Storage; Maintenance And Inspection; Repair And Modification - Olympus OER-Pro Operation Manual

Care and storage

Maintenance and Inspection

Repair and modification

ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
After use, reprocess and store this equipment referring to the instructions in
Chapter 5, "End-of-Day Checks" in this manual. Inappropriate care and storage
could present an infection control risk and/or cause equipment damage or
malfunction.
• The OER-Pro requires routine maintenance and inspection. In addition
to checks before use, the person in charge of maintenance and
administration of the medical equipment at the hospital should
periodically check all of the items described in this manual. If any
irregularity is observed, do not use the equipment and inspect it as
described in 8.1, "Troubleshooting guide" on page 274. If the irregularity
is still present, the equipment must be repaired prior to next use.
• If the lamp of the PERIODIC MAINTENANCE indicator starts to blink,
described in Section 2.5, "Control panels" on page 28, the time for
regularly scheduled maintenance is near. When the lamp starts to blink,
be sure to contact Olympus immediately and perform the maintenance.
If you do not know when the lamp started to blink, do not use the device
and contact Olympus. Otherwise, effectiveness of the reprocessing may
be compromised.
Do not disassemble, modify or attempt to repair this equipment and its
accessories. Doing so could result in operator or patient injury and/or equipment
damage or malfunction. Some problems that appear to be malfunctions may be
corrected by referring to Chapter 8, "Troubleshooting and Repair". If the problem
cannot be resolved using the information in Chapter 8, "Troubleshooting and
Repair", contact Olympus.
Important Information — Please Read Before Use
13