Olympus OER-Pro Operation Manual page 273

1.
Take out the printer paper roll from the package and peel off the tape
holding the end of the paper.
Figure 7.110
2.
Make sure that the power switch is ON.
3.
Hold the printer cover handle and pull it toward the front.
Printer cover
Figure 7.111
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
If the end of the paper is not straight, trim it so that it is
perpendicular to the side edges. Otherwise, the printer paper
roll may not load properly in the printer.
Chapter 7 Routine Maintenance
267