Olympus OER-Pro Operation Manual page 144

Chapter 4 Reprocessing Operations
138
 ERROR RESULT PRINTOUT
The printer can prints error results by operation of "PRINT LAST" when error
occurs during the reprocessing process.
1.
When an error code is displayed, press the FUNC SEL button on the
subcontrol panel to select "PRINT LAST".
2.
Press the FUNC START button on the subcontrol panel. The printer prints
the error code detail information.
Figure 4.54
3.
The buzzer beeps and paper feed stops when printing is finished. Cut the
printed part of paper and ensure that the information is printed correctly.
• If the printout is not satisfactory, printing can be restarted.
Press the FUNC SEL button on the subcontrol panel so that
both the PRINT LAST and PRINT TODAY indicators light up
and then press the FUNC START button.
• The same information can be printed several times until the
next reprocessing process is started.
• For the printed information about "Error Results", refer to
"PRINT FORMAT (Error Result)" on page 146.
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual