Preparations Before Disinfection Of Water Supply Piping - Olympus OER-Pro Operation Manual

The disinfectant solution stored in the equipment is used for disinfection of the
water supply piping.
Confirm the disinfectant solution concentration using the
test strip.
(See Section 3.10, "Checking the disinfectant solution
concentration level" on page 59.)
If disinfection effect is OK
Drain water from the water filter housing.
(See "Draining water from the water filter housing" on page 193.)
If water drain is completed.
Disinfect the water supply piping.
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual

Preparations before disinfection of water supply piping

Figure 7.23
• Before disinfecting the water supply piping, check the
concentration of the disinfectant solution with the test strip,
and replace the disinfectant solution if the disinfectant
concentration is below the required level. If this check is not
performed, disinfection may be insufficient.
• Disinfection of the water supply piping is required each time
the water filter is replaced (i.e., at least once a month). There
may be other circumstances where this is required, for
example a flood or hurricane. Microbiological sampling of the
OER-Pro rinse water may indicate disinfection is required.
• Disconnect the connecting tubes from the connectors on the
device before disinfecting the water supply piping. Otherwise,
a jet of disinfectant solution may be output from the
connecting tubes and leak from a connector such as the gas
filter case connector.
• Before handling the disinfectant solution, read the
precautions carefully and use it as instructed. It is especially
important to know what to do if the disinfectant solution
comes in contact with your skin.
Chapter 7 Routine Maintenance
If disinfection effect is No Good
Replace the disinfectant solution.
(See Section 7.12, "Replacing the disinfectant
solution" on page 225.)
203